C2R-MIT Infinity Radio/Amp Replacement Harness for Mitsubishi

To RETAIN the "INFINITY" Radio and replace factory AMP & speakers.
1. Connect the DIN plug on the C2R-MIT to the DIN plug located at the factory amplifier/ ( under passenger front seat in most cars)
2. Connect the blue wire to the turn-on lead of the aftermarket amplifier.
3. Connect the RCA's to the inputs on the aftermarket amplifier.

Noteworthy
When retaining the radio and replacing the factory amp with an aftermarket amp:
In some instances the factory radio amplifier turn-on lead may not provide enough current to activate most aftermarket amplifiers. If the amp does not turn on with the radio a Low Voltage Trigger is required and highly recommended.
Click for INSTALLATION DIAGRAM.


1. The aftermarket replacement radio must have at least 4 RCA outputs otherwise Y-Adapter cables are required.
2. The C2R-MIT is required in Mitsubishi/Chrysler vehicles equipped with an "INFINITY" Audio System. Vehicles not equipped with "INFINITY" System do not need this part. See pull-down menu below for application.